Taller centre stand

As it says; what you've done to your bike and how it helped make it better.

Moderators: Gromit, Paul, slparry

Pete.
Posts: 238
Joined: Thu Apr 02, 2015 7:16 pm

Taller centre stand

Postby Pete. » Sat Aug 01, 2015 8:46 pm

I made a centre-stand for my R1100S. The stock one is too short for bikes fitted with the factory sports pack and don't lift the wheel off the floor so I made it taller than stock.

I cut the legs from steel tube and chopped a piece out of some old engine crash bars for the brace. Drilled the brace at the correct centres for the leg span.

Image

Cut the pivots from thick steel flat bar

Image

Image

Made a temporary spacer to hold the pivots at the correct centres an tacked them on

Image

Welded the brace in at the correct height

Image

Hack-sawed a fish-mouth at the top of the tube, crimped it in the vice and welded it fully. This is to add strength and to stop the tube filling with water.

Image

Image

Image

Welded the foot pads to the bottom of the tube, and then welded the stops on the inside of the pivots (not shown here)

Image

And a test-fit. Going to finish it tomorrow by fitting the spring peg, the rubber stop bracket and the foot lever then give it a coat of paint

Image

EDIT, all done. Need a spring is all:

Image

Return to “Boxerspex”

Who is online

Users browsing this forum: No registered users and 13 guests