Best Stripper?

[Harry Lime]

Deleted.

[McBoxer]

After reading the title and first few lines, I had a whole range of recommendations for you. However, on reading further I realised that you were after a different kind of stripper altogether

So, in order to do that single malt some justice; fire up the log burner, pour yourself a large dram, sit back in a comfy arm chair with your feet up - and send the parts off to someone else.
You know it makes sense!

[Merecat]

Nitromors Is your friend here.
Splosh it on and scrub it off with a stiff brush.

[Corvus]

After reading the title and first few lines, I had a whole range of recommendations for you. However, on reading further I realised that you were after a different kind of stripper altogether
.........D

Yes, I expect this thread will have a high view hit rate!

[eyore]

Nitromors Is your friend here.
.

Only if it lands where its intended to do so..................otherwise its your enemy. And don't imbibe till the job is done.

[Bikerhoss]

Fine sanding disk/pad/brush and an angle grinder


and that IS how I did mine actually gave quite a good even finish if you were of the polishing mind

[Boxadog 2000]

Nitromors Is your friend here.
Splosh it on and scrub it off with a stiff brush.

Nitromores and ally do not mix well.

Get a specific stripper for ally or just Vapor blast which is a really nice finish for ally.

Then spray with clear lacquer it will be a finish that you will be impressed with.

[tanneman]

I had mine bead blasted to get rid of the paint in the most inaccessible places. The surface finish is rough as manufactured so a fair bit of polishing is going to happen. I painted mine by the way.