Removing bar risers and torque values
Posted: Fri May 18, 2018 12:14 pm
Hi all,
Bought an ST for my dad but it has bar risers - these need removing asap as it's almost unrideable in a progressive way sitting in that position hahaha
So, is it as simple as loosing the clamps in the yoke, loosing the bolts on the clip-ons and the risers, lifting off the clip-ons, removing the risers, shift the fork leg down so that the clip ons can be re-attached below the yoke and then tighten everything up again?
At least seems that simple to me but might be wrong.
The next question really is what the bolts need torquing down to, that is, the yoke, the clip ons and the bolt securing the clip-ons to the yoke (and any other i might have missed).
Let me know your thoughts please - thanks a lot!!!
Bought an ST for my dad but it has bar risers - these need removing asap as it's almost unrideable in a progressive way sitting in that position hahaha
So, is it as simple as loosing the clamps in the yoke, loosing the bolts on the clip-ons and the risers, lifting off the clip-ons, removing the risers, shift the fork leg down so that the clip ons can be re-attached below the yoke and then tighten everything up again?
At least seems that simple to me but might be wrong.
The next question really is what the bolts need torquing down to, that is, the yoke, the clip ons and the bolt securing the clip-ons to the yoke (and any other i might have missed).
Let me know your thoughts please - thanks a lot!!!