Refitting drive shaft to gearbox output

Got a technical query? Found another 0.02bhp? Ask/tell the world.

Moderators: Gromit, Paul, slparry

Jmhill
Posts: 7
Joined: Sat Jun 16, 2018 1:10 pm

Refitting drive shaft to gearbox output

Postby Jmhill » Tue Oct 15, 2019 2:54 pm

Hi,

I’m trying to put my bike back together after what I thought would be a simple job of changing the swing arm bearings. Removing the swing arm and drive shaft have proven to be one of the most challenging mechanical problems I have ever attempted and I have tackled a few. I have encountered problems all of the way and reassembly is proving a nightmare!

The driveshaft is supposed to push over a snap ring circlip located in a groove in the gearbox output shaft. The drive shaft cannot be hammered on due to two floppy u-joints. There is no way the drive shaft will push over the snap ring the groove isn’t deep enough to allow it to compress into it. I cannot see how you can fit the circlip after installing it as the U-joint will be in the way.

Any help please!!!!!

Thanks

Jon

Jmhill
Posts: 7
Joined: Sat Jun 16, 2018 1:10 pm

Re: Refitting drive shaft to gearbox output

Postby Jmhill » Tue Oct 15, 2019 4:40 pm

Solved my own problem the circlip locates in the rear of the U-joint not on the shaft.


Return to “Boxertech”

Who is online

Users browsing this forum: No registered users and 58 guests